November 7, 2026 · 4 min read
Expansive clay soil and concrete in San Antonio
The ground under San Antonio moves more than most. Here's what the soil data says and how to pour for it.
If you’ve lived in San Antonio for a while, you’ve probably seen it. Doors that stick in August and not in March. A driveway that cracked the same summer as the neighbor’s. A patio that tilted toward the house. A lot of it comes from the ground.
What expansive clay is
Some clay soils soak up water and swell, then shrink as they dry. The change can be large. When the ground under a slab swells, it pushes up. When it dries and shrinks, support drops away.
That cycle happens every year here. Wet spring, dry summer, wet fall, and sometimes a long drought. A slab on top rides every swing.
What the soil data says
The USDA keeps a soil survey for the whole country. One of the measurements is linear extensibility, which describes how much a soil changes in volume between wet and dry. Roughly, under 3 percent is low, 3 to 6 is moderate, and over 6 is high.
Here’s what the survey shows for the dominant soil at the center of each area we work in:
| Area | Dominant soil | Linear extensibility | Movement |
|---|---|---|---|
| Helotes | Anhalt clay | 11.4% | High |
| San Antonio | Branyon clay | 9.9% | High |
| Shavano Park | Crawford stony and Bexar soils | 8.3% | High |
| Alamo Heights, Castle Hills, Terrell Hills | Eckrant cobbly clay | 4.9% | Moderate |
| Boerne | Oakalla silty clay loam | 3.2% | Moderate |
| Fair Oaks Ranch | Boerne fine sandy loam | 1.3% | Low |
Same metro, very different ground. Helotes sits on some of the highest movement soil in the area. Fifteen miles north, Fair Oaks Ranch sits on soil that barely moves at all.
These numbers describe the dominant soil at the center of each town. Your lot can differ. Look up your own address on the Web Soil Survey, and get someone to look at the site.
How clay damages concrete
Clay rarely moves evenly. The edges of a slab dry out and wet up faster than the middle. Corners near downspouts stay wetter. Areas near trees dry out more because roots pull water.
So one part of a slab rises while another drops. Concrete is strong in compression and weak when it bends. Uneven support makes it bend, and it cracks.
Building for it
You can’t stop clay from moving. You can build a slab that rides the movement and stays in one piece.
A real base
Organic topsoil comes out. Fill goes in where it’s needed and gets compacted in layers. On high movement clay, a thicker layer of select fill under the slab helps buffer moisture changes.
Reinforcement in the right place
Rebar or wire mesh doesn’t stop cracks, but it holds them tight so the pieces stay together. It only works if it’s held up in the middle of the slab on supports. Mesh left lying on the dirt does nothing.
Tighter joint spacing
On clay, joints at the closer end of the usual spacing range give the slab more planned places to relieve stress. Our post on control joints covers how spacing is worked out.
Thickness sized to the load
Clay is less forgiving of a thin slab under heavy loads. Our post on driveway thickness covers the usual numbers.
Drainage
Water is what drives the movement. Every slab should slope away from the house. Downspouts should discharge away from slabs, not at their edges. Low spots that hold water next to a driveway should be regraded.
Keeping moisture steady
After the concrete is in, the best thing you can do is limit big swings in soil moisture around it:
- Keep gutters clean and downspouts extended.
- Don’t let irrigation soak one side of a driveway while the other stays dry.
- Watch large trees planted close to slabs, which pull water from the soil in summer.
- Seal open joints and cracks so rain doesn’t run straight into the base.
What to ask a contractor
Ask whether they’ve checked the soil for your area and what they’ll do differently because of it. If the answer is the same for a lot in Helotes and a lot in Fair Oaks Ranch, that tells you something. Each of our area pages lists the dominant soil from the USDA survey, because a slab on Helotes clay and a slab on Fair Oaks Ranch loam are not the same job.
Our driveway page covers how we build. For a written estimate, call or text (210) 761-6960.
Sources and further reading
Keep reading
Want someone to look at it?
Free estimate. Tell us about the job.
Rather talk? Call or text (210) 761-6960
FAQ
Common questions
How do I find out what soil is under my house?
The USDA Web Soil Survey is free. Draw a box around your property and it lists the soil types, along with properties like shrink swell potential. It describes the general area, so a site visit still matters for the details.
Can you build a driveway that won't move on clay?
Not one that never moves at all. You can build one that moves as a unit and holds together, by compacting the base, reinforcing the slab, cutting joints close together, and keeping water from soaking the edges.
Does watering my foundation help concrete on clay?
Keeping soil moisture steady around slabs and foundations can reduce swings between swelling and shrinking. The goal is consistent moisture, not flooding. Fixing gutters and slope that send water under a slab usually matters more.
Get a written estimate
Free estimates across San Antonio and the Hill Country.
Request an estimateOr call or text (210) 761-6960